W211SCN coding online with JDiag Elite Pro + DAS

This is how to use JDiag Elite Pro programming tool for Mercedes W211online

SCN coding with DAS.

Model:

Mercedes Benz W211.056

Module for coding:

W211.056 Transmission

Device can be used:

JDiag elite pro programming tool

SD connect c4 multiplexer

How to do W211SCN coding online:

Check connection of the car and diagnostic tool

Run Jdiag Mercedes software DAS

Transmission

Confirmed VIN stored in control module and go on

Warning:

-connect battery charger

-make sure that the diagnostic plug is properly seated in the diagnostic socket

-the diagnostic connector must remain plugged in to the vehicle

-switch off all electrical consumers

-if possible, do not perform any procedures on the vehicle during control unit programming

Daimler login

Continue

Data is being determined

Important note:

-secure vehicle to prevent it rolling away and apply parking brake

-the teach-in process for the selection range sensor may only be performed after the shift rod has been properly set

You will guided through the following steps:

-teach-in selection sensor range in selector lever position P

-teach-in selection sensor range in selector lever position R

-teach-in selection sensor range in selector lever position N

-teach-in selection sensor range in selector lever position D

Initial startup was fully completed

Result:

Successful!

Perfect scn coding online for W211.056 Transmission with Device JDiag elite pro II

OBD2France.com all rights reserved, Original Article url:W211SCN coding online with JDiag Elite Pro + DAS

admin